The Conquest demands all of its components to be absolutely top-tier in performance, build quality and reliability. The choice for an amplifier was very easy for us to make in this regard. We again chose BASH technology for this powerful subwoofer and the results are amazing.

The platform has been increased to a full 1000 watt RMS design. Like all of our amplifiers, it will also provide even higher power during short-term dynamic peaks. The custom amplifier design was built just for the Conquest. It was tested and retested until we had a component that exceeded our expectations.

This incredibly powerful amplifier ensures that our massive driver is always under control. A large amount of high-tolerance output devices supply the power to retain an iron-clad grip over the driver’s movement. They also allow the Conquest to achieve enormous output levels.

The Class D switching amplifier design means that even with a lot of power being generated, it still maintains optimum efficiency. On top of this high quality amplification, we utilize several large extruded aluminum heatsinks both inside and out of the amplifier. The largest heatsink is placed outside the amplifier to quickly and effectively draw heat outside of the enclosure and away from the amplifier.

The preamplifier section utilizes a Class AB design. This means that the signal stays pure and clean right up until it is handed off to the power section. Yes, the Conquest shares the same fantastic sound quality as the rest of the Epik subwoofer lineup.

Standard features include implementations for adjusting the gain to match the rest of your system as well as a crossover to blend in the subwoofer with your speakers. Power can be set to “auto” as well as on or off. The phase on the Conquest is fully adjustable in order to fine-tune its in-room performance with your system.

Inputs are provided for simple hookup to any music or movie system. High and low level inputs are both standard. Low level outputs also offer the ability to loop the signal elsewhere or hook up multiple subwoofers together. You can also bypass the Conquest’s crossover settings with the flip of a switch so you can control it via your receiver or home theater preamplifier or processor.

This is our highest power and most costly amplifier. It saw quite a bit of attention during the design phase, and the results are very easy to hear. The sound quality and output capabilities that this amplifier gives the Conquest are absolutely reference quality.